Table of Contents
Advertisement
Gas connection
The inlet gas pipe may be flexible or rigid and must have a diameter of R 1/2 or even more.
In case of flexible pipes it must be an homologated product approved by local norm.
Between the device and the supply gas network must be installed a proper homologated valve as settle in the current
laws.
Before connection you have to check if the gas available in the place corresponds to the type fixed in the device (see plat
serial number).
Before switch on the device check if the connection is properly tightened. To check the eventual leakages use of any
kind of flame is strictly forbidden.
Picture 2
Entry gas Rp 1/2 on the valve
Gas entry Rp 1/2
Boschetti Industrie Meccaniche srl
Picture 3
Entry gas Rp 1/2 on the valve
6
IT
Ver. 01/2018
Advertisement
Table of Contents
