8/30
Bosch Rexroth AG
General safety instructions
2.5
Adhere to the following instructions
2.5.1
General notes
•
Observe the regulations on accident prevention and environmental protection
for the country where the product is used and at the workplace.
•
Rexroth hydraulic systems should be used only if in a sound technical condition.
•
Check the product for visible defects, for example cracks in the housing or
missing screws and seals.
•
Do not modify or retrofit the off-line filter system.
•
Only use the product within the performance range provided in the technical data.
•
Persons who assemble, operate, disassemble or maintain Rexroth products
must not consume any alcohol, drugs or pharmaceuticals that may affect their
ability to react.
•
The warranty only applies to the delivered configuration. The warranty expires if
the product is incorrectly assembled, not used as intended and/or handled im-
properly.
•
Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handle or step. Do not place any objects on top of it.
2.5.2
During assembly
•
Make sure the relevant system component is de-pressurized and de-energized
before assembling the product or when connecting and disconnecting connec-
tors. Protect the off-line filter system against re-activation.
•
Lay the cables and lines so that they cannot be damaged and no one can trip
over them.
•
Before commissioning, make sure that all the seals and caps of the plug-in
connections are installed correctly and undamaged to ensure that fluids and
contamination parts are prevented from penetrating the product.
•
When assembling, provide for absolute cleanness in order to prevent welding
beads or metal chips from getting into the hydraulic lines and causing product
wear or malfunctions.
2.5.3
During commissioning
•
Let the product acclimate itself for several hours before commissioning, as
otherwise water may condense in the housing.
•
Make sure that all electrical and hydraulic connections are either used or cov-
ered. Commission the product only if it is installed completely.
2.5.4
During operation
•
In case of emergency, failure or in case of other irregularities switch off the
system and secure it against re-activation.
30, 50, 80 NFF2 | RE 51433-B/04.10