Operating Pre-Conditions - Siemens SIPROTEC 7SJ80 Product Information

11

Operating Pre-conditions

For most of the operational functions, the input of passwords is necessary.
This applies for all entries which concern the operation of the device, for
example configuration, setting of functional parameters, or initiation of test
procedures. If the device provides control functions which allow operation
of the switch gear, passwords are equally required before any switching
commands be carried out.
Password input is not required for read-out of annunciations, operating
data or fault data, or for read-out of setting parameters.
The following ranges of access authorization are defined:
switching/marking/matching,
non-interlocked switching,
tests and diagnosis,
individual parameters,
hardware tests,
parameter groups.
Depending on the scope of functions of the device, one or the other
access authorization may be omitted.
Input of the password is requested, if applicable, during operation with
DIGSI® or from the front of the device.
You should change the passwords at last after completion of commission-
ing in order to prevent the device from unintentional alterations or from
unauthorized operation. Passwords can be changed only by means of the
program DIGSI®.
SIPROTEC 7SJ80 / 7SK80 V4.60, Product Information
E50417-K1150-C342-A6, Edition 07.2010
Note:
All passwords are preset with the 6-figure code
000000.
39