Page 2
“animal” lens (supplied with the product). Adding additional products (if necessary) Products that are not part of the Pack TYXAL+ Access must be associated with the system: - connected home hub TYDOM 1.0, ... - intruder detectors and technical detectors, - keypad, badge reader, remote controls, etc.,...
Page 3
Installing and mounting the products 1.1 CS 2000 TYXAL+ control unit 1.2 CLT 8000 TYXAL+ touch screen key- • Location The alarm control unit should be installed: • Location - On a fl at surface, with enough space all around for installati on and It is advisable to install the touch screen keypad: opening the batt ery cover.
Page 4
Installing and mounting the products 1.3 DMB TYXAL+ motion detector • Mounting DMB TYXAL+ uses infrared (heat) to detect any moving presence in the room. It has 2 removable lenses: ❶ Open the unit. - no. 1: standard (fi tt ed on the product supplied). - no.
Page 5
Installing and mounting the products 1.4 Door/window magnetic contact DO TYXAL+ • Activation The DO TYXAL+ Detects when a door or window is opened and reports this to the alarm control unit. Lithium battery - AA LS 14500 3,6 V •...
Page 6
Installing and mounting the products Close the alarm control unit Configuring butt ons 1 and 2 Mode A ..Mode B ❶ Replace the cover of the ❷ Screw in the closing screw siren and replace the protecti ve tab Mode C >...
Page 7
Creating your access codes • from the installer code • General ❶ Enter the installer code (123456, by default) and confirm with OK. The access codes (6 digits) are recorded in the alarm control unit. You configure the access codes once with the CLT 8000 TYXAL+ touch screen keypad and the other products (keypads or transmitters) recognise these codes ❷...
Page 8
Adding additional products (if necessary) Products that are not part of the TYXAL+ Access Pack must be associated • Add your telephone/tablet to the alarm system with the system: - intruder detectors and technical detectors, - keypad, badge reader, remote controls, etc., - indoor siren, telephone transmitt er, etc., To do this, refer to the «Adding products»...
Personalising the installation and the products Testing the installation The CLT 8000 TYXAL+ touch screen keypad allows all the personalisati on operati ons of the system. Test under operating conditions The following menus can be accessed by the installer code. The CLT 8000 TYXAL+ touch screen keypad can be used for all acti vati on acti ons.
Overview of your installation Activation date: ........Name and stamp of installer: ........Items of the pack: No. or name of Immediate/delayed Type Name Comment (e.g. location) zone triggering DMB 0 01 02 Example: Zone 1 or Home Delayed (30 s) Ground floor corridor Motion detector or Corridor 1...
Need help?
Do you have a question about the Pack TYXAL+ Access and is the answer not in the manual?
Questions and answers