3
The baseplate is attached to the insert with two rivets at the front. By pushing on the top of the insert you
can tilt the insert upwards, allowing for better access to the area under the insert (see Figure 4). A bracket
is provided on both sides to prop the insert up (see Figure 5). Rotate these bracket down.
4
The snap disc is installed from behind the insert (see Figure 6). Attach the wires labeled "SNAP DISC" to
the snap disc and slide it into the snap disc holder.
NOTE: The snap disk holder may be on the right or left, depending upon when the insert was
manufactured. See Figure 7 and Figure 8 for pictures of the two locations.
Figure 7
Page 2 of 6
Fan, DVI Insert – 31 and 33 DVI
Installation Instructions
Figure 4
Figure 6
17601587 - 12/20/10
(sku 99000167)
Figure 5
Figure 8
© Travis Industries, Inc.