Electrical Equipment - Bentone BG 300LN Installation And Maintenance Instruction

ELECTRICAL EQUIPMENT

Control program when disruption; disruption display
Gas burner control: LME....
Colour codes
Diagnostics alarm trigger
lights red
AL
FS
Limit on start attempts
Colour code table for multi-coloured signal lamps (Light diodes)
Status
Waiting time «tw», other waiting times
Ignition phase, ignition checked
Normal operation
Operation, poor flame signal
Prohibited flame signal during start up
Undervoltage
Disruption, alarm
Flashing code for fault codes
Interface diagnostics
Continuous
Off
The red alarm signal lamp lights continuously after the alarm is disconnected.
Diagnostics for alarm triggers can be read as specified by the following sequence:
Light period (waiting time
LME 11 ... limits the number of start attempts if the flame does not ignite on start-up
or goes out during operation. LME 11 ... permits a maximum of three start attempts
if the start cycle is uninterrupted.
Colour codes
Red
Yellow
Green
Press the reset
10 s) Flash code
button > 3 s
20
Colours
Off
Flashing yellow
Green
Flashing green
Green-Red
Yellow-Red
Red
Flashing red
Red flickering
Pause Flash code
Approx. 3 s
1(2)
172 445 02 08-01