Table of Contents
Advertisement
7.2.7 Run the engine and rotate the cutting tool (FIGURE 8 NO.0KT010200-1611) by pressing
the button marked in (FIGURE 2 NO.1EL090000-0500) continuously.
7.2.8 By the help of joystick arm (FIGURE 2 NO.1EL090000-0500) on the head, move the head
and execute a process on profile. In order to reach requested depth, use up and down
motion control arm (FIGURE 2 NO.2TU011510-0081).
7.2.11
Remove the suspension pin from the socket on the template in order to process free from the template.
7.2.12
You can adjust the movement area of the head with locking parts (FIGURE 2 NO.2TU012210-1258-
3UA040030-0008) when making free processes.
7.2.13
Leave the button after the process finishes. Cutting tool stops after rotating nearly 10 seconds out of gear.
7.2.9
When the button on the joystick arm is pressed,
cooling water is sprayed from the valve which is shown right.
Spraying is stopped by pressing the same button again. If
wanted, the amount of spray is adjusted by using the turning
bar on the valve.
7.2.10
In order to down the arm, brake should be
released by pressing on the button over the arm. For security
reasons, cutting tool does not operate when arm is most
upward position.
Advertisement
Table of Contents
