Table of Contents
Advertisement
Troubleshooting
Figure 7: Removing a backup unit
Ê Remove the four screws (1) and remove the defective unit from the frame in
the direction indicated.
To install a backup unit, you follow the same procedure in reverse order:
Ê Before you install a new backup unit, set the SCSI ID (see section "Setting
the SCSI ID" on page 20).
I
A flat cable is used for the internal SCSI cabling.
16- bit devices are connected directly, 8-bit devices require a 50-to-68-
pin adapter. Mixed operation using both 8-bit and 16-bit devices is
therefore possible.
U41181-J-Z156-1-74
Replacing the backup unit
29
Advertisement
Table of Contents
