Drive Assembly; Adjusting Tension Of Drive Belt; Installation; Door Connection - ABON Ultra S Installation And Operating Instructions Manual

Drive assembly

[4-14] See installation scheme (image
part).
Adjusting tension of drive
belt
[15-] Tighten safety nut (24), until the
drive belt (5) does not lie tight in-
side the guide rail (10) and is
slightly tightened.

Installation

[17-29] See installation scheme (image
part).
Support drive with suitable aids
after lifting towards the ceiling and
secure against falling. Inspect mount-
ings at ceiling and lintel again after
installation [23,24,29].

Door connection

Depending on the door type, there
are different installation sets available.
Connect door and drive according to the
instruction, enclosed in the installation
set.
If the door cannot be coupled with
the drive, the sled (4) has to be run in
closing direction by means of button 2 of
the transmitter, or the sled has to be un-
locked. Couple door for performing of
learning runs [35]. If the end position
has been activated unintentionally, the
mains plug has to be unplugged for 2
seconds (=reset).

Control components

Control and display elements [30]
1 „Impulse" button
2 „Program" button
3 LED (red)
4 LED „Power" (green)
External connections [30]
5 Emergency stop
6 Safety strip/optical sensor/light barrier
(SE/LS)
7 Impulse
8 Antenna A = Antenna
E = Earthing
Putting door drive into
operation
Connect antenna
[31] Unpack hand-held transmitter and
antenna.
[32] Connect antenna (8) to external
terminal (8, right screw terminal A).
Connect to mains power
[33] Open door slowly by hand until the
sled audibly snaps in.
[34] Plug in mains plug. The LED „Pow-
er" (4) must light, the drive lamp
flashes 4 times.
Make sure that no people, ani-
mals or objects are in the range of
movement of the door before activat-
ing the drive.
Basic settings (learning of
end positions and forces)
For performing basic settings
the door drive must be coupled with
the door. During learning there is still
no protection by the safety switch-off
due to excess force.
There are two learning
possibilities:
• With transmitter [35]
• Without transmitter [36-39]
Learning with transmitter
Button 1: Dead man operation and fine-
tuning up
Button 2: Dead man operation and fine-
tuning down
Button 3: Confirmation (save)
Button 4: Confirmation (save)
End position „UP"
[35] Activate button 1 and keep it
pushed, the door moves to open.
At the moment, where the desired
end position „UP" is reached, re-
lease button 1.
A correction of end position „UP" is
possible by pushing button 2.
Confirm reached end position
„UP" by short pushing of button
3 or 4, the drive lamp flashes
3 times. After learning end position
„UP", the door is run automatically
in closing direction. The drive stops
automatically, once the right closed
position is reached.
English
47