Table of Contents
Advertisement
PROGRAMMING A CONTROL POINT
Control Points
The operating characteristics of the Door Operator are adjusted by means of 28 Control Points, numbered 00-27.
At the factory, the Control Points are set at values suitable for the most common swing door application:
•
Function: Push
See Control Point 14
•
Reveal: 2.5 inches
See Control Point 1
•
Weight: 125 lb.
See Control Point 3
You may have to change one or more of the factory settings to fine-tune the Door Operator to your specific
application. The information you need to program Control Points is presented on the following pages.
There are three types of Control Points:
•
Settings that specify a unit of measure, for example: seconds.
•
Relative values, for example a scale of 1 to 10 representing a range from minimum to maximum.
•
On or Off: a feature is activated or deactivated.
19
Advertisement
Table of Contents
