Table of Contents
Advertisement
WARNING: Ensure that 115VAC
power is OFF before touching wires.
Step #4:
Pull conduit and external
component wires through frame and
cutout(s) in mounting plate. Allow at
least 10 inches of exposed wire for
electrical connections.
Step #5:
Mount the door operator to the mounting plate with four M8x25 screws and washers provided.
Note: Mount the operator with the power switch end cap toward the door hinge.
PULL TYPE APPLICATION
INSTALLATION INSTRUCTIONS
CONDUIT
FRAME
DOOR
END OF CONDUIT MUST
NOT PROTRUDE PAST
THE SURFACE
WALL
GREEN (GND)
DOOR
OPERATOR
SPACER
(IF REQUIRED)
PULL ARM
TRACK
ROLLER
(CAP NOT SHOWN)
MOUNTING
PLATE
WHITE (+)
BLACK (–)
MOUNTING
PLATE
DOOR
FRAME
9
Advertisement
Table of Contents
