Maguire S Blender
Weigh Bin Assembly Removal, Inspection, Cleaning
The Weigh Bin Assembly is accessible though the Back
Door Assembly. The Back Door Assembly is secured to
the frame assembly with 2 latches.
1. To access the Weigh Bin Assembly, un-hook the
latch, and gently lower the hinged Back Door
Assembly down onto the Mix Motor.
2. Detach the Dump Valve Air Line.
3. Hold the Dump Valve closed while sliding the
weigh Bin out of the Frame Assembly.
4. Clean and inspect the Weigh Bin. Using
compressed air, remove any debris, dust or pellets
from the Load Cell hangers and from the
surrounding camber. At this time, you have access
to the Load Cells within the Frame Assembly. If
necessary, they can be examined to be sure they
are free of interference and can be replaced if
necessary.
8
Maguire Products, Inc.