Re-Installation Of The Mix Chamber And Mix Blade - Maguire Products S-BLENDER Supplimental Documentation

Maguire S Blender
4. Remove the Mix Chamber. Note that the Mix
Chamber dump port is closer to the Front Door
Assembly. This opening at the base of the Mix
Chamber must be re-installed in the same
orientation, with the Mix Chamber opening directly
over the opening of the of the Mix Chamber Saddle
located directly below the Mix Chamber.
Clean and inspect the Mix Blade, the Mix Chamber,
5.
and lower area of the Frame Assembly.

Re-Installation of the Mix Chamber and Mix Blade

1. Slide the Mix Chamber into the Frame Assembly.
Orient the Mix Chamber Dump port so that it is
directly above the Mix Chamber Saddle. The port
will be closest to the Front Door Assembly.
2. Insert the Mix Blade keyed end first. The end of
the Mix Blade will slide over the Mix Motor shaft.
Allow it to rest in the Mix Chamber.
3. Close the Front Door Assembly.
While closing the door, carefully
reach into the Mix Chamber and lift
the Mix Blade to allow the shaft to
slide into the Mix Blade Shaft
Collar. Close and latch the lower
half of the Front Door Assembly.
4. Lift the upper half of the Front Door Assembly and
insert the keyed Safety Interlock Switch. Close the
upper latch of the Front Door Assembly.
7
Maguire Products, Inc.