Daikin FXZQ-M Series Engineering Data page 24

EDUS39-800-F9
 Never inspect or service the unit by yourself.
Ask an authorized service person to perform this work.
 Cut off all electric waves before maintenance.
 To avoid the risk of serious electrical shock, never
sprinkle or spill water or liquids on the unit.
Placing a flower vase or other containers with water or
other liquids on the unit could result in a shock hazard or
fire if a spill occurs.
 Operating the air conditioner with wet hands could
result in a shock hazard.
 Do not allow children to play on or around the unit as
they could be injured.
 Check the unit stand for damage on a continuous
basis.
If left in a damaged condition the unit may fall and cause
injury.
 The heat exchanger fins are sharp enough to cut.
To avoid injury wear gloves or cover the fins while working
around them.
 Do not put a finger or other objects into the air inlet
or air outlet.
The fan is rotating at high speed and will cause injury.
 Do not touch the air outlet or the horizontal flaps
while the swing flap is in operation as fingers may
get caught and injured.
 Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in
electric shocks or fire.
 Never touch the internal parts of the controller.
Do not remove the front panel because some parts inside
the controller are dangerous to touch. In addition, some
parts may be damaged. For checking and adjusting the
internal parts, contact your dealer.
CAUTION
 Do not use the air conditioner for other purposes.
In order to avoid any quality deterioration, do not use the
unit for cooling precision instruments, food, plants, animals
or works of art.
 Do not place items under the indoor unit which may
be damaged by water.
Condensation may form if the humidity is above 80% or if
the drain outlet gets blocked.
 Avoid placing the controller in a spot splashed with
water.
Water coming inside the unit may cause an electric leak or
may damage the internal electronic parts.
 Do not operate the air conditioner when using a room
fumigation - type insecticide.
Chemicals from the insecticide deposited into the unit,
could endanger the health of those who are hypersensitive
to chemicals.
 Do not turn off the power immediately after stopping
operation.
Always wait at least 5 minutes before turning off the power.
Otherwise, water leakage and trouble may occur.
 The appliance is not intended for use by young chil-
dren or infirm persons without supervision.
 The remote controller must be installed in such a
way that children can not play with it.
FXZQ-M
 Consult with the installation contractor for cleaning
the inside of the air conditioner.
Wrong cleaning may be the cause for plastic parts to break,
water leakage or electric shock.
 Do not touch the air inlet or aluminium fins of the air
conditioner.
Otherwise, injury may be caused.
 Do not place objects in direct proximity of the out-
door unit and do not let leaves and other debris
accumulate around the unit.
Leaves are a hotbed for small animals which can enter the
unit. Once in the unit, such animals can cause malfunc-
tions, smoke or fire when contact with electrical parts.
NOTE
 Never press the button of the remote controller with a
hard, pointed object.
The remote controller may be damaged.
 Never pull or twist the electric wire of the remote
controller.
Pulling or twisting the electric wire may cause the unit to
malfunction.
 Do not place appliances which produce open fire in
places exposed to the air flow from the unit or under
the indoor unit.
Not following this advice may cause incomplete combus-
tion or deformation of the unit due to the heat.
 Arrange the drain hose to ensure smooth drainage.
Incomplete drainage may cause wetting of the building, fur-
niture etc.
 Do not place the controller exposed to direct sun-
ligth.
The LCD display may get discolored, failing to display the
data.
 Do not wipe the controller operation panel with ben-
zine, thinner, chemical dustcloth, etc.
The panel may get discolored or the coating peeled off. If it
is heavily dirty, soak a cloth in water-diluted neutral deter-
gent, squeeze it well and wipe the panel clean. Wipe it a
second time with another dry cloth.
 Dismantling of the unit, treatment of the refrigerant,
oil, and eventual other parts, should be done in
accordance with the relevant local and national reg-
ulations.
 Do not dry the filter by exposing it to direct sunlight or
warming it using fire, etc. Doing so can result in the
deformation of the filter.
Installation and Operation
23