General Information - DEVA Broadcast DB91-TX Setup Instructions

How can the db91-tx be used as an rtp sender, sending audio to db91-rx decoder used as an rtp receiver

Hide thumbs Also See for DB91-TX:

The IP Audio encoder and decoder are controlled trough a build in WEB Server and a standard

web browser is used to monitor their status or to make some adjustments. To operate the devices

you need to know their IP Address. In case you are not aware of the IP Addresses and how to open

the WEB interface, please refer to

"Appendix B - DB91-RX Quick User Guide" on page

This configuration is perfect if your setup requires only point-to-point connection. It has a

minimum and almost constant delay value (usually less than a second).

DB91-TX AND DB91-RX SET-UP

Prior to implementing the below written adjustments, the following requirements should be

fulfilled:

•

DB91-TX should be connected to a Network (Internet or LAN).

•

DB91-TX could be set with dynamic IP.

•

DB91-RX configured as RTP receiver with static IP.

•

If the DB91-RX is placed behind a router, you will have to make sure that the RTP Receiver

port is properly NAT forwarded.

DB91-TX RTP SENDER SET-UP

1. Go to Settings> Input;

2. Choose the preferred audio signal input;

3. Press [Save];

E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com

General information

"Appendix A - DB91-TX Quick User Guide" on page 9

- 4 -

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria

Tel: +359 56 820027, Fax: +359 56 836700

13.

and

Table of Contents