Advertisement
The IP Audio encoder and decoder are controlled trough a build in WEB Server and a standard
web browser is used to monitor their status or to make some adjustments. To operate the devices
you need to know their IP Address. In case you are not aware of the IP Addresses and how to open
the WEB interface, please refer to
and
"Appendix B - DB9009-RX Quick User Guide" on page
This configuration is perfect if your setup requires only point-to-point connection. It has a
minimum and almost constant delay value (usually less than a second).
DB9009-TX AND DB9009-RX SET-UP
Prior to implementing the below written adjustments, the following requirements should be
fulfilled:
•
DB9009-TX should be connected to a Network (Internet or LAN).
•
DB9009-TX could be set with dynamic IP.
•
DB9009-RX configured as RTP receiver with static IP.
•
If the DB9009-RX is placed behind a router, you will have to make sure that the RTP
Receiver port is properly NAT forwarded.
DB9009-TX RTP SENDER SET-UP
1. Go to Settings> Input;
2. Choose the preferred audio signal input;
3. Press [Save];
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
General information
"Appendix A - DB9009-TX Quick User Guide" on page 9
2
- 4 -
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
13.
3
1
Advertisement
