Advertisement
Available languages
Available languages
From the flue gas probe
End piece
Inlet filter
Outlet filter
End piece
To the analyser
Filter tube
Withdrawing
screw
Flexible flue gas probes 0600.9430 / 0600.9440
For flue gas probes with condensate trap:
Emptying the condensate trap
Pull off one of the two end pieces from the condensate
trap and pour out the condensate.
Changing the filter
If dirt is visible on the output filter, the inlet filter should
be removed.
Remove filter if pump power drops (audible). Changing
the inlet filter is sufficient in most cases.
Filter tube
Remove the small filter pipe to change the filter. Screw
the withdrawing screw into the filter and remove from
the filter pipe. Press new filter firmly into the filter pipe.
Only spare parts from Testo should be used
(Part no. 0554 3371).
The c c ondensate t t rap s s hould b b e e e mptied i i f t t he
pump i i s s s witched o o ff.
The c c ondensate t t rap i i s d d esigned i i n s s uch a a w w ay
that t t here i i s a a c c ertain f f low d d irection. T T his i i s m m ar-
ked w w ith a a rrows o o n t t he h h ousing s s ection. I I f g g as
flows i i n t t he o o pposite d d irection t t he c c ondensate
trap c c annot f f unction p p roperly a a nd t t his c c ould l l ead
to t t he i i nstrument b b reaking d d own.
When a a ssembling t t he c c ondensate t t rap, e e nsure
that s s ealing r r ings a a re n n ot d d amaged a a nd t t he f f ilter
tubes d d o n n ot g g et m m ixed u u p.
0973.0348/01/T/dr/05.09.2008
Advertisement
