Chicago Pneumatic CPF 270 Instruction Book page 59

Instruction book
Delay at start, starter feedback contact =
open
Delay at signal, starter feedback contact =
closed
Delay at start, electric condensate drain
Delay at signal, electric condensate drain
Service settings
Service plans
Service plan A (operating hours)
Service plan B (operating hours)
Service plan C (operating hours)
Service plan D (operating hours)
Service plan I (operating hours)
Analog inputs
Service warning level for oil separators
Service warning level for oil separators
Delay at signal, oil separator
Service warning level for air filters
Service warning level for air filters
Delay at signal, air filter
Terminology
Term
ARAVF
Required stop
period/Minimum
stop time
Power recovery
time
2920 1796 01
Explanation
Automatic restart after voltage failure. See section Electronic control system.
Once the compressor has automatically stopped, it will remain stopped for the minimum
stop time (approx. 20 seconds), whatever the net air pressure. In automatic operation, the
compressor will not be stopped by the regulator until a standstill period of at least the sum
of the minimum stop time and required stop period is expected. However, if the decrease
in air net pressure should require a new start of the compressor, the regulator will start the
compressor after the minimum stop time.
Is the period within which the voltage must be restored to have an automatic restart. Is
accessible if the automatic restart is activated. See section Electronic control system. To
activate the automatic restart function, consult your Customer Centre.
Minimum
setting
sec 0
sec 0
sec 0
sec 5
Minimum
setting
hr
hr
hr
hr
hr
Minimum
setting
bar 0
psi 0
sec 0
bar -0.1
psi -1.45
sec 0
Factory Maximum
setting setting
13 60
2 3
15 60
5 5
Factory Maximum
setting setting
4000
8000
16000
24000
2000
Factory Maximum
setting setting
0.8 0.8
11.6 11.6
60 255
-0.05 -0.05
-0.7 -0.7
60 255
57