Chicago Pneumatic CPF 270 Instruction Book page 24

(5)
(6)
• Section A shows information regarding the compressor operation (e.g. the outlet pressure or the
temperature at the compressor outlet).
• Section B shows Status icons. Following icon types are shown in this field:
• Fixed icons
These icons are always shown in the main screen and cannot be selected by the cursor (e.g. Compressor
stopped or running, Compressor status (running, running unloaded or motor stopped)).
• Optional icons
These icons are only shown if their corresponding function is activated (e.g. week timer, automatic
restart after voltage failure , etc.)
• Pop up icons
These icons pop up if an abnormal condition occurs (warnings, shutdowns, service,...)
To call up more information about the icons shown, select the icon concerned using the scroll keys and
press the enter key.
• Section C is called the Status bar
This bar shows the text that corresponds to the selected icon.
• Section D shows the Action buttons. These buttons are used:
• To call up or program settings
• To reset a motor overload, service message or emergency stop
• To have access to all data collected by the regulator
The function of the buttons depends on the displayed menu. The most common functions are:
Designation
Menu
Modify
Reset
To activate an action button, highlight the button by using the Scroll keys and press the Enter key.
To go back to the previous menu, press the Escape key.
Selection of a main screen view
To change between the screen layouts, select the far right icon in the control icons line (see value lines display
icon in section Icons used) and press the Enter key.
Select the layout required and press the Enter key.
22
Running hours
Compressor outlet
Function
To go to the menu
To modify programmable settings
To reset a timer or message
Instruction book
2920 1796 01