Advertisement
Required Tools
Anti-static wrist strap
Appropriate tools for installation
and wiring
Socket set/adjustable wrench
Voltmeter
Installing the Equipment
The following procedures are general steps for a typical installation. For specific instructions, see the RM4200
Series User Guide (part no. 122206-000) available from your website account under the Help menu.
WARNING
To prevent electrostatic discharge (ESD) damage when handling electronic equipment, always wear an anti-
:
static wrist strap attached to an unpainted, grounded metal object. Ensure the wrist strap has maximum contact with
bare skin.
WARNING
To keep exposure of radio frequency energy below limits mandated for permissive exposure, do not operate
:
the RM4211 within 20 cm of any part of the body.
WARNING
Before beginning any wiring to the RM4211, disconnect all equipment from hazardous voltages.
:
:
NOTE
For safety precautions for wiring power supply and unit inputs, see RM4200 Series User Guide.
1
Prepare for Installation
For pole or surface mounting - attach flat
base adapter to adjustable bracket. Install a
1/2" fitting into bottom opening on the base.
2
Make Connections From Device to RM4211
Connect RM4211 to the device to be monitored using either the included wired connector (test station) or
1
existing wiring from the device (such as a rectifier).
If connecting RM4211 to a Bullhorn-ready coupon test station, remove the shorting plug from the 8-pin
2
connector before connecting it to the RM4211.
If wires are to be buried or covered, use conduit to protect the wires.
WARNING:
© 2018 American Innovations, Ltd.
RM4211 Installation & Configuration
Magnet
Smartphone or tablet with iOS 8.1 or
Android 7 or later
Bullhorn
Tools Mobile
®
Flat Base Adapter on Bracket
Flat Base Adapter on Bracket
8-pin
connector
structure
coupon
coupon
Quick Reference Guide
For test station mounting - slip
test point adapter over and onto
the test station. Rotate adapter
clockwise until it is firmly secured
on the test station .
shorting plug
reference cell
1 of 2
Optional Tools
Small slotted screwdriver
Wire stripper and wire cutter
Amp clamp
Adapter
on Test Station
8-pin Connector for
RM4211 and Test Station
(Continued on back.)
Part No. 122235-000, Rev.0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bullhorn RM4211
Summary of Contents for Bullhorn RM4211
- Page 1 Flat Base Adapter on Bracket Make Connections From Device to RM4211 Connect RM4211 to the device to be monitored using either the included wired connector (test station) or existing wiring from the device (such as a rectifier). If connecting RM4211 to a Bullhorn-ready coupon test station, remove the shorting plug from the 8-pin connector before connecting it to the RM4211.
- Page 2 RM4211 ® are general steps to configure the RM4211 for service using the mobile app. Swipe a magnet across the access point (marked by an triangular indentation on the dome) on unit dome. The indicator light will blink on/off, which indicates that the unit dome.
Need help?
Do you have a question about the RM4211 and is the answer not in the manual?
Questions and answers