IBM 7014-T00 Manual page 64

Item
5
6
5. Ensure that the nut on the ground lug in the mounting plate is tight.
6. Locate the Y-shaped ground cable.
Note: The remaining steps can be used to install AC outlets on the front or the rear of the rack.
7. Place the star washer onto the ground lug of the front AC outlet-mounting plate.
8. Place the lug on the long end of the ground cable onto the ground lug.
9. Place a ground lug nut onto the ground lug and securely tighten it.
10. Route the cable under the rack.
11. Position the front AC outlet-mounting plate onto the rack.
12. Install the front AC outlet-mounting plate screws (stabilizer mounting screws) into the mounting
plate and through the mounting holes in the rack. Securely tighten the screws.
13. Place the star washer onto the ground lug of the rear AC outlet-mounting plate.
14. Place the lug on the short end of the ground cable onto the ground lug.
15. Place a ground lug nut onto the ground lug and securely tighten it.
16. Connect the Y-shaped end of the ground cable to the rack frame, either near the center in the rear of
the rack or to the ground bus bar at the rear of the rack.
17. Position the rear AC outlet-mounting plate onto the rack.
18. Install the rear AC outlet-mounting plate screws (stabilizer mounting screws) into the mounting plate
and through the mounting holes in the rack. Securely tighten the screws.
Installing the AC outlet-mounting plate without AC outlets
If you choose to install an outlet plate without the outlets, perform the following tasks.
1. Ensure that the nut on the ground lug in the AC mounting plate is tight.
50 Power Systems: Racks and rack features
Description
Button-head screw
Ground lug
Item Description
11 AC power cable from power
source