IBM 7014-T00 Manual page 133

Procedure
1. Read the "Rack safety notices" on page 1.
2. Install the door latch on the right and the door hinges on the left.
3. For a high-perforation front door, align the door over the rack hinge, then move up the hinge pin on the
door, and lower the hinge pin into the hinge.
4. Adjust the latch so the door latches securely.
Attaching an acoustic door
You might need to attach an acoustic door to the rack. Use the procedure in this section to perform this
task.
About this task
Note: This door only hinges on the left side. The steps to install the door are the same for the front of the
rack and for the rear of the rack.
To install the acoustic door, complete the following steps:
Procedure
1. Read the "Rack safety notices" on page 1.
2. Using two screws, attach the hinge brackets, one on the top and one on the bottom. - Using two
screws, attach the catch bracket.
3. Lift the pin into the up position in two locations on the door.
4. Align the door over the hinge brackets.
5. Lower the two pins in the door to engage into the barrel of the hinge bracket.
6. Adjust the latch so the door latches securely.
7. Install the door latch on the right and the door hinges on the left.
8. Adjust the latch so the door latches securely.
Changing the side on which your rear door opens
You might want to change the way that the door opens on the rear of the rack.
About this task
To change the way that the door opens on the rear of the rack, complete the following steps:
Procedure
1. Read the "Rack safety notices" on page 141.
2. If it is already installed, remove the door.
3. Determine whether you want the door to open to the right or left.
If you want to change the way that the door opens, move the rack hinges (A) to the other side of the
rack. If you move the rack hinges, remove the latch bracket (B) and install it on the other side of the
rack.
Racks and rack features 119