Regulatory Statements; Notice For U.s.a - HP ProCurve Radio Port 230 Installation And Getting Started Manual

Safety and Regulatory Statements

Regulatory Statements

Regulatory Statements

Notice for U.S.A.

Manufacturer's FCC Declaration of Conformity Statement
Product No:
FCC ID No:
Regulatory Model No:
Manufacturer::
Phone:
For questions regarding this declaration, contact the Product Regulations Manager at the above address or phone
number.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this
device may not cause harmful interference, and 2) this device must accept any interference received, including inter-
ference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
The FCC requires the user to be notified that any changes or modifications made to the device that are not expressly
approved by the Hewlett-Packard Company may void the user's authority to operate the equipment.
A-2
Tested to Co mply
w ith FC C S ta ndards
J9004A, J9006A
B94RSVLC-0502, B94RSVLC-0505
RSVLC-0502
Hewlett-Packard Company
3000 Hanover Street
Palo Alto, CA 94394-1185 USA
650-857-1501
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.