Suspended Ceiling Tile T-Bar Mount; Ceiling Mount Hardware; Ceiling Mount Procedure; To Install The Radio Port On The T-Bar - HP ProCurve Radio Port 230 Installation And Getting Started Manual

Suspended Ceiling Tile T-Bar Mount

Mounting the Radio Port 230 or 210 to a suspended ceiling T-Bar grid consists
of attaching the radio port to the underside of a T-Bar in a suspended ceiling
grid, and twisting the radio port to lock the case onto the T-Bar.

Ceiling Mount Hardware

Safety wire-recommend between 1.01mm (.04in.) and 1.58mm (.06in) and
■
security cable (optional)

Ceiling Mount Procedure

To Install the Radio Port on the T-Bar:

1. Lift the ceiling tiles around the T-Bar where the radio port is to be installed.
2. Loop a safety wire around the tie point, secure the loop and attach the
opposite end to a secure point on the ceiling or T-bar grid.
3. Install a security cable to the radio port's lock port and secure the opposite
end to a secure, stationary point on the ceiling.
4. Plug the Ethernet cable into the RJ-45 jack and connect the opposite end
to a switch with an IEEE 802.3af-compatible power source. Thread the
cable through the ceiling T-Bar grid on the proposed radio port installation
side.
5. Position the radio port so the back of the radio port faces the bottom of
the T-Bar. Position the radio port case so that the T-Bar fits into the channel
formed into the underside of the radio port case.
6. Slide the radio port until the T-Bar Suspension Clip on the opposite side
of the radio port case slips over the T-Bar. Rotate the radio port counter-
clockwise slightly (approximately 15 degrees) to lock the remaining T-Bar
Suspension Clip into place. The T-Bar Retaining Clip clicks into place as
the Suspension Clips fasten onto the T-Bar. (See following diagram)
Installation Instructions
Suspended Ceiling Tile T-Bar Mount
2-7