Bathtub Additives; Filter Basket Maintenance; J6 Control Panel Swirlpool™ System Reference Illustration - Jacuzzi Arga Swirlpool Operating Instructions Manual

Operation & Maintenance Instructions

Bathtub Additives

CAUTION: Do not use oil or oil-based bathtub additives. Never use abrasive cleaners on any Jacuzzi Luxury Bath product.
Arga™ Swirlpool™ bathtubs are intended for use with Jacuzzi® Epsom Salts.
If you want to use any other kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance; the
system action intensifies the foaming properties of soaps.
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub residue in
the system and may cause false reading of the water level sensors. If excess accumulations persist, you should discontinue use of
these products.

Filter Basket Maintenance

After each use, remove & rinse the filter basket to remove any residue (Fig.
3).
ATTENTION: If anything becomes trapped or dried into the strainer,
first soak the filter basket in dish soap and warm water, then scrub as
needed with a brush.
J6 Control Panel Swirlpool™ System Reference Illustration
WATERFALL
BUTTON
SWIRLPOOL™
BUTTON
ILLUMATHERAPY™
BUTTON
Page 8
CONTROL KIT
CONTROL PANEL
PUMP SALT DISCHARGE
ON/OFF VALVE
www.jacuzzi.com
Arga™ Bathtubs
Fig. 3
120V 15A
GFCI
LIGHT WIRING CONNECTORS
4-PIN RECEPTACLE
4-PIN PLUG
LIGHT WIRING, 1600MM
JET ASSEMBLY
W/ LED
NOT USED IN
4-JET CONFIG.
LIGHT WIRING, 500MM
Operation Instructions