Klarstein 10032463 Manual page 34

EN
34
Dehumidify (DRY) mode
In dehumidify (DRY) mode, the temperature cannot be adjusted, the ventilation will fix at
low speed. When the unit is operating in Dehumidify ( DRY) mode, humidity extracted
from the air is collected in an internal tank. If the tank reaches full, the compressor
and motor cut out automatically. At the same time, the "Water Full" indicator comes
on. An alarm will also sound. When the tank is full, drain the water as shown in the
page concerning "DRAINAGE". You may also use the unit without having to empty
the tank so often by using "continuous drainage", please also refer to the page about
"DRAINAGE".
Self-diagnosis (shows when you turn on the machine)
This machine is equipped with self-diagnosis function. If something is wrong in
the machine, the LED will show the word "E1". It means the sensor wire for room
temperature does not connect well (this wire is located in the center of the evaporator).
Note: As this time, please call your service centre. Please DO NOT dismantle the
machine by yourselves in any case.
Notes on Remote Control
All the above functions can also be performed
with the supplied remote control.
This remote control requires 2 pcs AAA batteries
to operate (battery is not supplied along with the
unit).