Assemblies & Set Up; Connecting Cable To Battery; Recharging New Machine - Bushranger 7101E-RIDER Operator's Manual

ASSEMBLY & SET UP - Overview
Before you open the carton of your new riding mower, please review the following:
WE RECOMMEND YOU HAVE A SECOND PERSON ASSISTING BEFORE YOU BEGIN.
•
Remove the over shipper carton by lifting it straight up and over the enclosed wooden panel that houses and protects
the unit.
•
Install grass deflector and make sure it remains attached to the mower for side discharging.
Re-connecting cable to battery
For transportation safety, the battery cable have been disconnected. The
cable connector should be re-connected before using this machine.
•
Tilt the seat plate forward.
•
Unscrew the lock nut with attached spanner or wrench to unlock the
rear case, and then tilt the case backward.
•
Reconnect the cable.
•
When you are finished, carefully close the rear case and lock it back
into place.
NOTE: make sure that there are no open circuits or loose wiring
BEFORE closing the rear case.
•
Carefully turn and lower the seat back to its original position.
Recharging your new machine
NOTE: Your new machine may have insufficient power after delivery.
You need to plug in your machine to help ensure it is fully charged
before starting. Charge the 72V lithium polymer battery for 8-10 hours to
ensure a full charge. Carefully read Operator's Manual or ask your local
Bushranger dealer for details.
Charging should be carried out in the ideal surrounding temperature from
0 to 40°C.
WARNING
Do not short circuit battery wires. Remove any jewelry before working
on or near the battery or electric start system. Failure to follow these
instructions could result in personal injury or properly damage. Keep the
charger out of reach of children.
- Fig 1
- Fig 2
bushrangerpe.com.au
Cable connector
Fig 1
Fig 2
12