Canon imagePRESS C1+ User Manual page 49

10
Press [-] or [+] for <Back Side> to input the number of pixels to shift the image.
Input the value from the test print paper.
Following the example in step 9, input [-6] for <Back Side>.
[+]:Press when the center line of the register mark is located outside the edge of the test print (the
center line of the register mark is NOT printed). The image is shifted the number of pixels entered
right the feeding direction of the paper.
[-]:Press when the center line of the register mark is located inside of the edge of the test print. The
image is shifted the number of pixels entered left the feeding direction of the paper.
11
Press [OK].
12
Perform the test print again, and check the location of the image.
Repeat steps 6 to 11 until the center line of the register mark aligns with the left edge of the paper.
IMPORTANT
When you open the [Image Location Adjustment] screen again after you close that screen by pressing [OK], the
values on screen are returned to [0]. Nevertheless the adjusted value is effective. If you repeat steps, read off the
value of register marks from new test print and input the new value.
13
Press [Done].
49