General Description; Design; Control Panel; Control Center St - SAFEMATIC ST-1340 Manual

CONTROL CENTER ST-1340

1 GENERAL DESCRIPTION

ST-1340 is a microprocessor-based control center for SAFEGREASE, SAFEOIL and
MULTILUBE lubrication systems. The control center can be used for controlling 1 to 4 separate
lubrication channels or systems. ST-1340 controls lubrication according to its settings and it
also saves the lubrication event history onto a CPU-card. It will send an alarm to the system for
possible malfunction immediately.

2 DESIGN

Note
ST-1340 control center main switch (pos. 1) is located on the side of the center enclosure. The
enclosure cover has a green LED-signal for power (pos. 2) and a red LED-signal for alarm
(pos. 3). Center control panel (pos. 4) is located on the cover inside the enclosure. Each
channel module (pos. 5) contains the I/O-connections required for controlling one lubrication
channel.

2.1 Control panel

Control panel is used to program the lubrication, to reset alarms and to monitor lubrication
phases.
It has a 4-line x 20-character LCD (4 lines x 20 characters) with four (4) function keys below the
display, 12-key keypad for entering alphanumeric data and a CPU-unit.
CH2 SG2 Machine 1
Interval 012h10min
L1:005bar L2:005bar
Chnl Page
Figure 1.
13401BEN.doc
Numbers in brackets are part numbers of drawing 461838A.
Extr Manu
Display and function keys
SAFEGREASE, SAFEOIL, MULTILUBE
ST-1340
1 (19)
27.12.2004 Rev. 1B