Assembly; Using Giant Tubeless Ready Wheelsystems With Tubeless Tires - Giant WheelSystem Manual

 If you encounter difficulties, or are uncertain about anything identified in this user's manual,
please contact your local authorized Giant retailer.

ASSEMBLY

Using Giant Tubeless Ready WheelSystems with tubeless
tires:
CAUTION: When assembling Giant Tubeless Ready WheelSystem (including rim tape,
tubeless valve, tubeless sealant, and tubeless tire), please refer to the set up instructions issued
by Giant or consult a qualified professional bicycle mechanic.
1. A tubeless tire should only be installed on a rim with "Tubeless Ready" marked on the
appearance of a Giant WheelSystem.
2. When assembling a Giant Tubeless
Ready WheelSystem, please use it in
combination with tubeless rim tape,
tubeless valve, tubeless sealant and
tubeless tire. If your wheels are to be
used with rim brakes, we recommend
to use Giant heat resistant tubeless
rim tape.
3. When installing the rim tape, please
ensure the tape is set in the center of
the rim bed, and make sure that the
tape overlaps 15cm on both sides of
the valve hole (Fig. 1).
4. For the installation of the tubeless
valve, please see figure 2 and figure
3.
Please ensure that the provided o-
ring seal is positioned correctly
between lock-ring and rim (Fig. 2)
Attach the lock-ring to the valve and
tighten it finger tight (max. 0.5Nm). Do
not use any kind of tools to tighten the
valve.
5. For the installation of tubeless tires,
please see page 4."How to install tubeless tires on Giant Tubeless Ready
WheelSystem."
6. For filling the sealant, please see page 5 "How to fill sealant into Giant Tubeless
Ready WheelSystem."
2