Chopping; Cleaning After Chopping - Morphy Richards FP401011 Instructions Manual

FP401011 MUK REV 1.qxp_Layout 1 10/08/2016 11:40 Page 7

Chopping

1. Firstly, assemble the Driving Shaft
Base (9), making sure it is clipped into position
2. Place the Chopping Jug
aligning with the unlock position and turn anti-
clockwise locked into position. The Food Processor
will not work if it is not correctly in place.
3. Insert the Chopping Blade
(8) securely. Make sure it is pressed into position.
WARNING: Sharp blades.
4. Place the prepared food into the Chopping Jug (7).
The food must be cut into small chunks.
5. Place the Lid (3) onto the Chopping Jug
it clockwise until locked into place. Make sure it is
locked in position correctly, otherwise the appliance
will not start.
6. Plug into the wall socket and set the Speed Dial
to your desired speed.
7. There are four settings: P , 0, 1 and 2. The 1 setting is
the low speed, the 2 setting is the high speed. Turn
the Speed Dial (10)
pulse. Release it to return to the 0 positon. The
pulse mode allows you to create a burst of power
for quick, powerful blending.
8. Turn the Speed Dial
the appliance after chopping. Open the Lid
remove the Chopping Blade (6). To remove the
Chopping Jug (7), turn anti-clockwise to release
from the Motor Base
CAUTION: The Blades are extremely sharp,
handle with care.
Below are foods that are not suitable for chopping.
Hard substances: Cheese, dried fruits and certain
vegetables (Carrots and Celery)
Soft Substances: Certain vegetables
(Onions and Spinach)
Raw and cooked meat: (boned and sliced)
CAUTION: The total operating time should not be
more than 90 seconds.
(8) onto the Motor
(7) on the Motor Base (9),
(6) onto the Driving Shaft
(7) and turn
to the P position and hold it to
(10) to the 0 position and unplug
(3) and
(9) Empty the chopped food.

Cleaning After Chopping

1. Unplug from the power socket before cleaning
2. Empty the Chopping Jug (7), dismantle all
detachable parts and wash with warm, soapy water
and dry thoroughly.
CAUTION: Care must be taken when handling
the blade as it is very sharp.
3. Wipe the Motor Base
thoroughly. Never immerse it in water. Ensure the
interlock area is free from food.
QUICK CLEANING
Pour some water (200ml) and a drop of washing up
liquid into the Chopping Jug (7), turn and hold the
Speed Dial (10) to the P position for a few seconds
for quick cleaning. (Chopping Blade to be fitted to
agitate the water).
(10)
(9) with a damp cloth and dry
7