Maintenance And Cleaning - Sunrise Medical JAY ZIP Back Owner's Manual

E N G LI S H
MAINTENANCE
• Sunrise recommends that all fasteners be checked
for wear, such as loose bolts or broken components
every 6 months.
• loose fasteners should be tightened according to the
installation instructions.
• All fasteners should be tightened to torque
specifications as stated in the hardware installation
section.
• contact your authorized Sunrise Medical supplier
immediately to replace any broken components.
WARNING
• Do not continue to use the system after identifying
loose or broken components.
NOTE: A wrench has been included with the back for
your convenience.
EASY CLEANING (Fig.2.0)
CAUTION
When disassembling the back for cleaning, note the
position of the Velcro® lumbar Positioning components
for correct reassembly.
To clean back cover
Remove cover by detaching Velcro.
Detach cover from back shell.
locate zipper on bottom of the cover and unzip.
Remove foam with inner cover and turn cover inside out.
Zip cover closed to avoid snagging.
Machine wash in warm water (60°c).
Drip or tumble dry on low heat.
CAUTION
• Do not dry clean covers or use industrial washers
and dryers to clean cover.
• Do not steam autoclave.
• Do not bleach.
• Reinsert the foam with inner cover into the cover.
NOTE: The base has two layers of foam. When
reinserting the foam, ensure that the thinner, firmer, light
grey foam is facing the shell and the softer foam is facing
the user.
once the foam is secured inside the cover, zip cover
closed.
JAY Zip Back 122962

MAINTENANCE AND CLEANING

To clean back shell and Inner Cover
Shell and inner cover may be wiped clean with soap and
water.
no other maintenance should be required.
To clean positioning components
Positioning components can be wiped clean with soap
and water.
CAUTION
• Do not immerse positioning components underwater.
if you have any additional questions regarding cleaning
procedures, please contact your authorized Sunrise
Medical dealer.
lAUnDRY cARE SYMBolS
Fig.2.0
6
Machine wash in warm
water (60° c)
only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
US = Rev. A, EU = REV.2.0