Aux Unit Operation - Subaru 2001 Outback Owner's Manual

5-28
Audio

AUX unit operation

By connecting a commercial audio pro-
duct to the vehicle, such as a portable
audio player, you can hear its sound via
the vehicle's speaker.
For the audio input jack, a stereo mini pin
plug (3.5ø) can be connected. The con-
nection cable is available at electrical
appliance or similar stores.
To use the AUX unit:
1. Connect a portable audio player to the
AUX jack.
2. Press the AUX input selection button
"CD/AUX" on the audio control panel to
turn on the auxiliary audio input.
3. Play back the portable audio player.
Refer to the Owner's Manual of the
portable audio player.
NOTE
. The output sound of the portable
audio player is not loud, and the sound
via the vehicle's speakers that are
connected to the vehicle audio set is
very low. If you turn up the volume of
the audio set, the volume becomes
louder. However, when you change
the player to the other portable audio
player, the sound may become a lot
louder. Turn down the volume when
you change between them.
. In some cases, when the sound
volume of the portable audio player is
low, the sound becomes bad when you
turn up the volume of the vehicle audio
system. In this case, adjust the sound
volume of the portable audio player.
. In some cases, noise occurs be-
cause of a bad connection between the
portable player and the audio system.
Try cleaning the stereo jack and audio
plug.
. If noise is not reduced, check for
disconnection of the cord or malfunc-
tions of the portable player.