Table of Contents
Advertisement
T A C 7
A p p e a r a n c e
Cleaning the Instrument
In order to maintain accuracy the TAC7 should be operated in an environment free of dust and
other sources of contamination.
If necessary remove dust with a clean, lint free cloth or clean dry air.
IMPORTANT:
Remove AC power from the instrument before performing any cleaning
procedures.
CAUTION: DO NOT use any solvents to clean the instrument.
CAUTION: Use proper personal protective equipment (e.g., safety glasses)
when using compressed air.
If compressed can air is used for any of the cleaning procedures that recommend
air, do not invert or tilt the can during use. This could cause damage.
CAUTION: When using chemicals, always follow the manufacturer's personal
protection equipment recommendations in the chemical SDS.
Handling and Care of the White Tile and ColorChecker Target
NOTE: Make sure that the white calibration card and color calibration card are always stored in
their protective sleeves when not in use.
If the White Tile or ColorChecker target becomes dirty, brush them as gently as possible with a
dry cloth or blow with a can of compressed air. The tile or color chips can be marred in the
cleaning process, so cleaning liquids should never be used.
Replacing the Fuse
In the event the instrument does not turn ON when power is applied, verify that power is
available at the socket. If power is available, check or replace the instrument fuse as follows.
Replacement fuse (5 mm x 20 mm 3.15A, 250V time-delay fuse type)
1. Turn the power off on the front of the instrument and unplug the detachable line cord.
2. Insert a flat-blade screwdriver into the edge of the fuse carrier and pry out.
3. Remove the blown fuse from the carrier clip and discard.
4. Place the new fuse in the clip and reinsert fuse carrier into the fuse cavity. Make sure the
carrier is firmly seated.
5. Reinstall the detachable line cord.
18
C a p t u r e
S y s t e m
Fuse
Carrier clip
Flat-blade
screwdriver
Advertisement
Table of Contents
