Table of Contents
Advertisement
5. Place the sample on the sample plate in the cassette, and align the desired measurement
area below the measurement spot.
Measurement spot
6. Lift the sample plate up until it stops against the measurement spot and close the cassette
clamps.
Closed clamp
Sample plate
7. Insert cassette with sample into the drawer by placing the cassette over the alignment pins.
Front view of drawer
T A C 7
A p p e a r a n c e
Alignment pin
Alignment
pins
C a p t u r e
Sample
Closed clamp
Side view of drawer
S y s t e m
11
Advertisement
Table of Contents
