Kenmore 795.7507 Series Use & Care Manual page 14

REFRIGERATOR INSTALLATION
REMOVING AND REPLACING
REFRIGERATOR DOORS
WARNING
Excessive Weight Hazard:
Use two or more people to remove and install the
refrigerator doors. Failure to do so can result in back
or other injury.
WARNING
Electrical Shock Hazard
• Disconnect the electrical supply to the refrigerator
before installing. Failure to do so could result in
serious injury or death.
• Do not put hands, feet or other objects into the air
vents or bottom of the refrigerator. You may be
injured or receive an electrical shock.
Removing the Hinge Cover
Remove the screw from the hinge cover at the top of
the refrigerator. Lift the hook (not visible), located at the
bottom of the front side of the cover with a flat-heat
screwdriver.
Removing the Left Door
1. The water supply is connected to the upper right part
of the rear surface of the refrigerator.
Remove the clip in the joint area. Hold the water
supply connection and gently push the collet (1) to
detach the water supply line as shown.
2. Pull out the tube (2). Disconnect all wire harnesses (3).
Unscrew the ground wire (4).
3. Rotate the hinge lever counterclockwise (5). Lift the
top hinge (6) free of the hinge lever latch (7).
CAUTION: When lifiting the hinge free of the latch,
be careful that the door does not fall forward.
4. Lift the door from the middle hinge pin and remove
the door.
NOTE: Place the door, inside facing up, on a
nonscratching surface.
NOTE
Disassembling/Assembling the Water Lines
(1)
14
(2)
(3)
(4)
(7)
(6)
(5)
Collet
Tube
Insert line
Clip
(Correct)