Installation - Solar Storage Tank - Rheem Solar Premier Loline 590160 Owner's Manual And Installation Instructions

INSTALLATION – SOLAR STORAGE TANK
THIS WATER HEATER IS FOR OUTDOOR INSTALLATION IF AN IN-SERIES GAS BOOSTER IS
MOUNTED ON THE STORAGE TANK.
THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING.
Check the in-series gas booster is suitable for the gas type available.
(refer to the rating label on the in-series gas booster)
The system is suitable for installation with either one only CSA2013 or two only NPT200 or LCS solar
collectors.
IMPORTANT NOTES

Working on roofs is and should always be considered a hazardous activity, particularly early in the
morning, late in the evening, when the roof is wet and during and after periods of rain.

All work must be carried out in accordance with Local, State and Federal Occupational Safety, Health and
Welfare Regulations. In particular, the requirements for safety whilst manual lifting, working at heights and
on roofs.

Installers must be competently trained in:
Height Hazard Assessment

Working at Height Procedures

Assessment / Use / Wearing of correct height safety equipment (harnesses etc.)

All other relevant safety factors specific to the installation and maintenance work to be compliant with

suitable Occupational, Health and Safety Regulations / Codes.

All relevant permits shall be obtained from the regulatory authorities before commencing work to install
the solar hot water system.

All work carried out must be performed by appropriately qualified tradespeople or be suitably supervised
for trades assistant duties.

Every care must be taken to protect and warn occupants of the building and the public from personal injury
which may occur from falling tools, roof materials, fittings or any other hazards of a general nature.

Advise the occupants of any inconvenience which may occur due to disconnection of existing water and
electrical supplies.

The connection, attachment, integration or general association of other equipment or parts which either
directly or indirectly affect the operation or performance of this equipment could void the Rheem warranty.

All packaging materials must be removed from the solar storage tank prior to its installation. This includes
the removal of the cardboard base of the carton from the underside of the solar storage tank.
INSTALLATION STANDARDS
The water heater must be installed:

by a qualified person, and

in accordance with the installation instructions, and

in compliance with Standards AS/NZS 3500.4 or AS/NZS 3500.5:2012 Section 3 (for a Class 1a or
Class 10 building) as applicable under the Plumbing Code of Australia, AS/NZS 3000, and either AS 5601
or AS/NZS 5601.1 as applicable under local regulations, and all local codes and regulatory authority
requirements.
Warning: Temperature controllers or an EZiSET kit must not be fitted to an in-series gas booster as part
of a solar water heater system because water at a temperature much higher than the controller or EZiSET
setting can be delivered.
21