Ups Is Not Communicating - StorageTek L180 Reference Manual

Fault Isolation

UPS is Not Communicating

The following screen shows what happens if the UPS is not communicating.
The above status might be caused by:
• Disconnected cables
• The AP9606 card is not configured properly.
Check the status lights on the card.
Link RX/TX LEDs
Off
Flashing
Status LED
Off
Solid Green
Flashing Green
Solid Red
Flashing Red
4-4
The device which connects the Management Card to the
network is turned off or it is not operating correctly.
The card is receiving data packets from the network.
Indicates the status of the Management Card
The Management Card has no power.
The Management Card has valid network settings.
The Management Card does not have valid TCP/IP
settings.
A hardware failure has been detected in the
Management Card.
Contact StorageTek's Customer Support Services.
The Management Card is making BOOTP requests. If
you do not use a BOOTP server, you need to configure
the Management Card's TCP/IP settings.
First Edition 96047