Rear Door Replacement; Power Connections; Before Beginning - StorageTek L180 Reference Manual

Installation Overview

Rear Door Replacement

Some early model library rear doors are not compatible with the optional rack
cooling feature. Check the serial number of your library, if it falls within the
ranges listed, you need to replace the rear door.
The following table lists the serial number range, description, and field bill
number for the rear door.
Library
L180
L700

Power Connections

Make sure you have the correct power connections for this feature:
• The L180 library, UPS Model SU1400RM2U, uses an L5-15, locking 120 VAC,
15 Amp plug. The customers power source requires an L5-15R receptacle.
• The L700 library, UPS Model SU3000RM3U, uses an L5-30, locking 120 VAC,
30 Amp plug. The customers power source requires an L5-30R receptacle.
• The International feature (EPWR) uses a Hubbell 316P6W (plug) and
Hubbell 316R6W (receptacle).

Before Beginning

Before beginning these installations, make sure:
• You observe the information in
• All equipment has been received.
• There are two separate power sources; one for each UPS.
• The library and all tape drives are offline.
Note: For simplicity, this installation procedure uses figures of the L180 UPS;
3-2
Serial Description
Numbers
1 - 6015 StorageTek rear door
HP rear door
Sun rear door
NCR rear door
1 - 6798 StorageTek rear door
HP rear door
NCR rear door
the procedure is similar for the L700. Refer to the instructions sent with
the feature for specific information about how to install the UPS.
First Edition
"Safety Precautions" on page
Field Bill
101334
101336
101337
101338
101326
101339
101340
x.
96047