Table of Contents
Advertisement
▪ 04- Interior Follower
▪ 10- Interior w/ Delay
▪ 23- No Response Type
10. For Equipment type, tap to select (2) Motion.
11. For Equipment code, tap to select 9999 Alarm.com Image Sensor.
12. For Image Sensor ID, tap Learn to put the panel into learn mode.
13. Insert the batteries into the Image Sensor. The LED on the Image Sensor will progress from blinking red to solid
red to blinking yellow. This indicates the Image Sensor is in learn mode.
14. Wait approximately 20 seconds for the Image Sensor to enroll to the panel. The screen on the panel will display
the following: Found Image Sensor [x]. The LED on the Image Sensor will turn solid yellow indicating that it has
successfully found the panel. Tap Accept on the panel.
15. For Equipment age, tap to select the equipment age (i.e., New or Existing).
16. For Transmission delay, tap to select enabled or disabled.
17. For Voice descriptor, tap to edit the voice descriptor if desired.
18. For Sensor reports, tap to select enabled or disabled. (Enabled is recommended)
19. For Sensor supervised, tap to select enabled or disabled. (Enabled is recommended)
20. For Sensor chime, tap to select enabled or disabled.
21. Continue to edit next sensor or tap Return to System Configuration and tap Save to save the changes and exit.
22. After the Image Sensor LED has turned solid yellow, you must exit Add Mode on the panel (previous step). The
Image Sensor LED will alternate between green and yellow while the customer's device list is updated with
Alarm.com. The LED will turn solid green when the Image Sensor has been successfully added to the customer's
account.
Note: If you move (tamper) the Image Sensor after the LED has turned solid green, the Image Sensor will enter
test mode for 3 minutes indicated by red LED when motion is detected. You may continue with the mounting
portion of the installation when in test mode. For more details about the LED status, see
Reference
Chart.
The sensor is now learned into the panel. After enrollment, be sure to keep the sensor and panel powered so the sensor
can complete an initialization process with Alarm.com. This process will take several minutes. Images cannot be
captured until initialization is complete.
To verify that the initialization process is complete using the panel:
1. Go to the home screen.
2. Tap System Settings.
3. Enter the installer code.
4. Tap Installer Toolbox.
5. Tap System Configuration.
6. Tap Image Sensors.
7. Tap to select the Image Sensor to verify.
8. Verify Rules is showing as Synced.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Image_Sensor/Image_Sensor_Version_3/Alarm.com_Image_S
Image Sensor LED
Updated: Wed, 19 Jun 2019 01:34:38 GMT
7
Advertisement
Table of Contents
