Network Settings - BAS-IP AA-09 Series Manual

Information about operation modes
If you select the "Wall" mode, you must enter 4 digits of the building number, 2 digits of
the unit number, 2 digits of the floor number, and 2 digits of the apartment number to
call the desired monitor.
If you select the "Unit" mode, you must enter only 2 digits of the floor number and 2
digits of the apartment number to call the desired monitor.
You shouldn't select individual opreration mode for these panels. It is used only for
individual panels.
Language: Select interface language.
Building: Number of the building.
Unit: Unit number.
Index: Device number of the outdoor panel.
Password: System password to enter settings or WEB interface.
Volume: Loudspeaker volume of the outdoor panel.
Size: Select the camera stream resolution of the outdoor panel.
The number of the building and the unit should correspond to values of the internal
monitor that will receive an incoming call from the outdoor panel. If you have several
outdoor panels with the same logical address, then in the Index field you should specify
values 2, 3, 4, 5 etc., up to 9. If the logical addressing of the outdoor panel corresponds
to the address of the monitor, and the IP addresses of the devices are in the same
network segment, the devices will find each other and the call will be correct.

Network settings

Main network settings are configured in this tab.
Configuration through graphical interface – 12