Full Upgrade - Samsung ST70 Service Manual

4-4 Full upgrade

♦ How to execute the FULL firmware
The firmware is configured in the following structure.
Code area is where the execution codes to operate the camera are located, and the Partition [1:3] area is where the various resources neces
sary to operate the camera are saved. Among these areas, Partition 3 area is where the Defective Pixel adjustment data and Lens Shading
adjustment data are saved.
User Area is where the setting values are saved through the menu when the user uses the camera, and the adjusted data through integrated
process is saved.
code
► Reference of FULL version:
- As the version to update the Code + Partition [1:3] area, this protects the adjusted data saved in the User Area but resets the Defective
Pixel adjustment data and Lens Shading adjustment data. Therefore, you must recover the to previously adjusted data by readjusting
or by backing up the adjusted data.
- When executing a FULL version upgrade, the adjusted data will automatically be saved to the SD card and you
can upload the adjusted data back to the camera by referring to the following detail method.
- Adjusted data automatically saved to the SD card is composed of 3 files; LSCLUTO.BIN, DefectivePixel0.bin
and DefectivePixel1.bin.
1. Insert the SD card containing the FULL FW data file and Upgrade Script file into the camera.
* You need two files for FULL FW upgrade and the required files are FULL FW data file and Upgrade Script file.
* Because all data saved on the FLASH memory will be reset when you upgrade the firmware, back up your data before proceeding with the
upgrade.
2. Use the AC adaptor or fully charged batteries for the power.
- You can proceed with the upgrade only when the battery level is full (Icon showing full up to 3rd level).
3. Turn on the power of the camera.
SAMSUNG
<Table 4-2>
partition1
Power ON
partition2
Fig. 4-9
partition3 User Area
Firmware update
4-5