Upgrade - Samsung ST76 Service Manual

Firmware update

6-3 Upgrade

♦ How to execute the firmware
The firmware is configured in the following structure.
Code area is where the execution codes to operate the camera are located, and the Partition [1:3] area is where the various resources
necessary to operate the camera are saved. Among these areas, Partition 3 area is where the Defective Pixel adjustment data and
Lens Shading adjustment data are saved.
User Area is where the setting values are saved through the menu when the user uses the camera, and the adjusted data through
integrated process is saved.
Code
► Reference of general version:
- As the version to update the Code + Partition [1:2] area, this protects both the adjusted data saved in the User Area and
the Partition 3 area.
1. Insert the memory card containing the firmware data file and Upgrade Script file into the camera.
* You need two files to upgrade the firmware and the required files are firmware data file and Upgrade Script file.
* Because all data saved on the FLASH memory will be reset when you upgrade the firmware, back up
your data before proceeding with the upgrade.
2. Use the AC adaptor or fully charged batteries for the power.
* You can proceed with the upgrade only when the battery level is full (Icon showing full up to 3rd level).
3. Turn on the power of the camera.
6-4
<Table. 6-1>
partition1
Power ON
partition2
Fig. 6-6
Copyright© 1995-2012 SAMSUNG. All rights reserved.
partition3 User Area