PrismCut P20 User Manual page 9

Sure Cuts a Lot (MAC) - configure WiFi connection
WiFi is the recommended communication method for your MAC.
In Sure Cuts a Lot, click on the Cutter icon (red circle) to open the Cut Settings menu.
Select Model=PrismCut, Connection=TCP/IP and enter the IP address that will appear at the
top of your cutter's home screen after you connect the cutter to WiFi.
The IP number on the cutter and the IP number on the computer must match for WiFi to work.
(note: If you see HI-LINK_xxxx on your cutter it is not yet set up for WiFi)
If you do not see PrismCut as a selection under Model, look at the top line of your MAC screen
and select Cutter->My Cutter->Manage Cutters and add PrismCut
Click on Help->About Sure Cuts A Lot 4 Pro to ensure that your software version is 4.080 or
higher. Otherwise you may need to download and re-install the most current version of SCAL4
software. Older versions of software will not yet have the driver.
www.prismcut.com
Tip: Press TEST button to verify
your IP communications work
9
www.prismcut.com