Software Installation: Sure Cuts A Lot (Mac) - PrismCut P20 User Manual

1.5 Software setup: Sure Cuts a Lot (MAC)
If you purchased Sure Cuts a Lot 4 Pro with your cutter, you should have a card
that says Sure Cuts A Lot on the front. The back of the card contains a software
serial number (see the red oval below). You will need this software serial number
to register and download your Sure Cuts A Lot software. Note that the software
serial number is different than the hardware serial number of the cutter itself.
DO NOT LOSE THE CARD OR ACTIVATION CODE - KEEP IN A SAFE PLACE
Download software at:
Follow the instructions on the card that point you to the link where to enter your name, email
address and the Software Serial Number from the card. You will then be able to download the
software. Install the software on your computer as you would any other software.
Write down the email that you used for this activation as it may be needed in the future!
http://www.craftedge.com/register/scal4pro
www.prismcut.com
SW Serial Number
8
www.prismcut.com