Sub-Package Mode (Mode 2); Configuration Mode (Mode 3) - Ebyte E70-915T30S User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
The data output on the receiver is continuous, it meets the requirements for MODBUS continuous transmission and low
Advantage
latency.
The baud rates on both receiver and transmitter must be same. The module will raise its air data when the baud rate is raised,
Disadvantage
thus the receiving sensitivity will be lowered and operation range will be shorter.
Applications Applicable for those applications not requiring distance but continuous data and response time.
1. The "wireless air data rate" in the configuration commands is invalid (SPED.210 bits) and software will calculate
automatically.
2. 0000 and FFFF are the broadcast addresses, which can be used to monitor and broadcast.
Note
3. The addresses and baud rates must be same on both receiver and transmitter.
4. In continuous mode, both transmitter and receiver must be same model. For example, E70 (868T14S) and E70 (868T30S)
cannot communicate in continuous mode.

6.4 Sub-package Mode (Mode 2)

Status M0=0 M1=1 M2=0
Transmitting Wireless data transmission is available.
Receiving Wireless data receiving is available.
Baud rate & Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different baud rate but
air data rate same air data rate.
Very low air data rate can be configured for longer distance, the data continuousness between output data depends on the data
Advantage
packet length.
Since the air data rate is low and the receiver needs to wait for the data packet length or timeout byte numbers, it may caus e
Disadvantage
some delay, which depends on the actual value as set.
Applications Applicable for those applications requiring distance and continuous data while not requiring transmission speed.
1. Air data rate and baud rate are not relative; the values are valid.
2. 0000 and FFFF are the broadcast addresses, which can be used to monitor and broadcast.
Note 3. The addresses and air data rates must be same, but baud rates can be different on both receiver and transmitter.
4. The size of individual data packet depends on the subpackage size CHAN [7:5] (excluding address and channel for
directional transmission)

6.5 Configuration Mode (Mode 3)

Status M0=1 M1=1 M2=0
Transmitting Transmission not available, serial data received will be discarded.
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co,;Ltd
E70-915T30S user manual
14