Advertisement
6. Position the anchor bracket cover over
lower suspension arm. Insert
M10x75 mm bolts through bottom part
and use nuts provided to assemble
the two parts. Figure 11.
Torque the assembly to 37 ft. lbs.
(50 Nm). Figure 11a.
NOTE: Arrow cutout in anchor bracket
must face front of vehicle.
7. Secure the undercarriage to the rear
hub using the nuts provided in this
mount kit. Figure 12.
NOTE: If needed, take rubber
protector off of hub.
NOTE: Ensure that the cotter pin of
the axle nut does not interfere with the
undercarriage hub.
NOTE: Torque lug nuts to 60 ft. lbs.
(81 Nm) at this time.
Bolt
Figure 11
Figure 11a
Figure 12
-8-
Nut
Nut
Anchor
Bracket
Cover
Bolt
Nut
Advertisement
