Advertisement
REAR TRACK SYSTEMS:
1. Using a lifting device, raise the rear of
the ATV and install appropriate stands.
Ensure that the vehicle is immobilized
and safe to work on.
2. Remove rear wheels. Make sure that
wheel studs and wheel hubs are free
of dirt. Figure 8.
3. If applicable, remove the CV joint
protectors from the A-arm.
4. Remove bolt, washers and spacer
bushings from the rear stabilizing rod
end. Figure 9.
Insert the bolt in the anchor bracket.
Figure 9a.
NOTE: It is not possible to insert this
bolt once the bracket is attached to
the suspension arm.
Figure 8
Figure 9
Figure 9a
-6-
Bolt
Stabilizing Rod
Spacer Bushing
Washer
Anchor
Bracket
Bolt
Advertisement
