Advertisement
5. Position the bottom part of the
anchor bracket underneath the lower
suspension arm. Position the top part
over the suspension arm so the tab
slips in the slot in the bottom part.
Insert the M10x50 mm bolts through
the bottom and secure the two parts
together with the nuts provided.
Tighten assembly to 37 ft. lbs.
(50 Nm) of torque. Figure 18 and
Figure 18a.
6. Secure the undercarriage to the front
hub using the nuts provided in this
mount kit. Figure 19.
NOTE: If needed, take rubber
protector off of hub.
NOTE: Ensure that the cotter pin of
the axle nut does not interfere with the
undercarriage hub.
NOTE: Torque lug nuts to 60 ft. lbs.
(81 Nm) at this time.
Anchor Bracket
Figure 18
(Bottom Part)
Figure 18a
Figure 19
-12-
Bolt
Anchor Bracket
(Top Part)
Nut
Nut
Advertisement
