Page 1
CROSSLINE LASER LEVEL WITH PLUMB DOTS MODEL NO.: DT1H1V2PR DT1H1V2PG OPERATING TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND ALL WARNINGS INSTRUCTIONS AND INSTRUCTIONS BEFORE USE.
TABLE OF CONTENT SPECIFICATIONS ......................3 HAZARD SIGNAL WORD DEFINITIONS ..............3 GENERAL SAFETY RULES FOR OPERATION ............4 COMPONENT IDENTIFICATION ................5 OPERATION INSTRUCTION ..................6 CALIBRATION CHECK ....................7 MAINTENANCE AND SERVICE .................9 TROUBLESHOOTING ....................9 PRODUCT LABELS .....................10 WARRANTY INFORMATION ..................12 CROSSLINE LASER LEVEL...
Optional (Part No. DT01REC sold seperately) DATUM is constantly improving its products. All information in this manual is based on the latest product information available at the time of printing. The specifications outlined herein are subject to change without prior notice or obligation. The purchaser and/or user shall assume liability for any modification and/or alterations of this equipment from original design and manufacture.
GENERAL SAFETY RULES FOR OPERATION Read all safety warnings, instructions, illustrations and specifications WARNING provided with this laser level. Failure to follow all instructions listed below may result in personal injury. Save all warnings and instructions for future reference. • Do not stare into beam regardless of distance.
OPERATION INSTRUCTION BATTERY PLACEMENT • Your laser level requires 4 AA batteries. Use only new, high-quality battery for best results. • Locate battery compartment at the bottom of the laser. Insert batteries according to the symbols and polarity. • When the battery voltage is low, the indicator light will start flashing in which the batteries must be replaced.
CALIBRATION CHECK It’s possible for you to check the calibration of the laser. Calibration by yourself is only approximate and the accuracy of the calibration will depend on the care with which you proceed. TO CHECK THE LEVEL Checking the horizontal pitch calibration of the laser requires 2 walls, which must be at least 5 metres apart.
Page 8
CHECKING THE VERTICAL LINE Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m length on the wall, making sure that the bob can swing freely. Switch on the device and align the vertical laser to the plumb line. The precision is within the specified tolerance if the deviation between the laser line and the plumb line is not greater than ±...
MAINTENANCE AND SERVICE • Do not attempt to open the device. To ensure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centres. Contact your dealer for more details. • Do not drop, knock or shake the laser level as this will affect precision. •...
9328225049279 Supplier: Sup#: Contact: Email: 000SUZHFUK EK118DT-2P-RED Steven steven@fukudalaser.com Filename: Date: 02/07/2019 135040 DAT Crossline Laser Level with Plum Dots Red DT1H1V2PR Colours: Dieline Pantone 166 C Check corrections Warranty Spellcheck Die/Overprints Check shadows Delete extra art Spec/Swatches Country of Origin...
Any cost incurred by you in bringing the product to the place of purchase will be borne by you. Calibration and repair service Datum recommends to check instrument calibration at least once a year or on as needed basis. For calibration or repair service (not covered under warranty), please visit your place of purchase.